Feedback: Keep Toploader Opening Up
I've been experimenting, and think i've made some progress.
If you facedown toploaders, and keep the opening facing up, then the scanner does not jam up.
I started off as per the videos, and was getting a jam every 4-5 cards. By following the above, no more jamps after scanner over 50 cards. If you do get a jam, then you're lucky as only the back of the toploader gets a little marking on the plastic, but the card is unharmed.
In the software in need help to configure because the cards are all up-side-down, and also front and back are switched - file name is good, but the scan is doing the rear image first, so in Card Dealer Pro I have to swap each one individually.
*I did buy and install the 3D part.
Awesome finding. I will say that while I do not use toploaders due to scratching of the glass, if this is a good solution for you all who do use them, then awesome!! Thank you for sharing!!!